Move out of range error on Initial bed mesh set up
I just finished building my v core 4 Idex today and was trying to go through the commissioning guide. When I attempted to do the first bed mesh I got the following error that haults my progess:
Move out of range: 495.311 25.000 2.000 [0.000]
The head scans the front of the bed but then stops and prints this error. What should I check to find what I did wrong?
23 Replies
how big is your printer?
500mm
try this
@miklschmidt havent we tested the y directed mesh for idex already internally?
I had installed Ratos RC2 a few days ago and when I started to look at the update manager I fond that there was an update for Ratos. After I updated it ran the bed mesh perfectly first try.
nice
is this a skewed frame? it looks like my bed is really not flat
show the data on the right side
this graphic can be misleading, depending on the visualization settings
show the data on the right side
Like this?
just show the whole screen
Nevermind I understand
0.6 is a bit height for a 500
but you can totally use ti already
its not too bad
but you could most likely improve it a bit
Would I improve it by adjusting the skew>
make a mesh when the printer is cold
and bassed on that mesh you can improve it
this is cold
looks like its a bit skewed on the back
ok thank you, Ill follow the video on the guide from here
right back a bit down or left back a bit up
also make sure to make a ztilt before doing the mesh
Yes, @McPatt please make sure you update everything.
this looks like poor magnet sheet application or like something is stuck under your bed plate.