Toolhead x-offset is too high for the available parking space. V-Core4 IDEX
After upgrading to IDEX and then performing the VAOC calibration sequence, I cannot perform a basic test print to check the basic Z offset.
3 Replies
This is the variables as set by calibration? I assume the offset for X is what it is complaining about?
OK, so in printer.cfg, I slightly adjusted my axis limits and endstop positions to make up for the -7mm in X. One note, you cannot reduce below 455, as the VAOC macro errors out with a move to 455. Again, split the difference, -5 on the T1 (dual carriage) position and -2 on X, just to reduce the final offset to less than 1 in the resulting calibration
Again, this edit now got me below the 1mm limit to then no longer get the error at the start of a print.
