Error when trying to use VAOC
Error evaluating 'gcode_macro _START_VAOC:gcode': gcode.CommandError: VAOC safe_z value too low!
16 Replies
Hello.
Did you calibrate z offset?
If so, what values are you getting?
Yes I calibrated it’s at 0.048
0.048 is way low.
Is your beacon assembled correctly and not skewed?
Mind sharing a pic?
Maybe it’s a little skewed
Looks like it is… should be parallel with the bed
Are you using a rapido hf or uhf? And looks like it needs hot toghtening
Uhf I think
And can you share printer.cfg and ratos.cfg?
Yes 1 second
Check if the cable plug is not hitting something
There doesn’t seem to be anything but the cable plug is going right up against the thing
Maybe that is causing the beacon to not sit proprely
Seems straight enough to me
I reran the beacon calibration ratos and updated to see if it made any difference but I still get the same error. :/ is there any way to change the safe_z value?