Prime Line instead of Blob?
I am getting all sorts of blobs on my print and I wonder if they are coming from the prime blob at the start which engulfs the nozzle that then drags itself out of it.
Is there a way to switch this to a line in RatOS?
5 Replies
Solution
Prime line was deprecated.
The prime blob should remain stuck to the bed in the corner. If it gets dragged, you have bed adhesion problems.
The sequence is: blob, raise Z, go down in a diagonal until touching the bed to clean the tip of the nozzle. Blod should remain on the bed.
It does stick to the bed, but the nozzle drags through it and I'm sure there is residue that gets stuck to the nozzle and burns 😦
thats how it is supposed to work
this way you remove old filament residue from the nozzle
Thanks Helge! I thought it would be doing the opposite, maybe my snot is coming from somewhere else...