Configuration tool doesn't seem to update stepper motor information in RatOS.cfg

I originally installed RatOS v2.1.0-RC 2 on my VCore 3.1-400 with TMC2209s for my X and Y stepper drivers. Everything worked fine and while troubleshooting something else, I ended up replacing the TMC2209's with TMC2226. I powered the system down, installed the new drivers and then brought up the system and then changed the drivers via the Configurator. When double checking everything, I noticed the RatOS.cfg file didn't update with the new driver configuration. I have restarted the system several times since and have run through a few test runs. I know the 2226 are very similar to the 2209's, but was curious if it should have updated the cfg file? Are the 2 drivers treated the same by RatOS? I included screenshots for reference.

Solution:

There is no 2226 in klipper, as it's basically just a 2209 in a different package 🙂

Jump to solution