ab19 - Hi… I have a newbie question.. If I conn...
Hi… I have a newbie question.. If I connect HALMET to my circa '95 Yanmar engine’s senders, do I risk breaking signals to existing gauges? Is there amplification or signal boosting required? Trying to be cautious. Maybe overly so. Any advice would be greatly appreciated.
3 Replies
It'll be fine. HALMET inputs are high impedance and therefore pretty much invisible when you connect them in parallel to existing gauges.
@ab19 did you find where to buy a couple of male/female Yanmar harness wire connector to implement the signal reading interpose in a transparent fashion?
@Raffaele Montella I am under the assumption I can add new connections to the senders themselves and not mess with the existing wiring harness, which is a bit of a mess and half-working as it is.