pilote NAC 3 B&G

Hi, is the widget component "Autopilot head" working with B&G NAC 3 calculator connected in NMEA 2000? Can replace a AP44 or a Triton hardware remote control?
9 Replies
Teppo Kurki
Teppo Kurki8mo ago
Please explain what is autopilot head
Kalymnos
KalymnosOP8mo ago
It's a virtual remote control for the autopilot included in KIP
No description
Teppo Kurki
Teppo Kurki8mo ago
There’s #kip channel
Scott Bender
Scott Bender8mo ago
The B&G autopilots are not supported. https://github.com/SignalK/signalk-autopilot
GitHub
GitHub - SignalK/signalk-autopilot
Contribute to SignalK/signalk-autopilot development by creating an account on GitHub.
Kalymnos
KalymnosOP8mo ago
☹️ Ok, bad luck. I don't know if it is possible to get protocol from B&G. Is it open source??? I can try to investiget
Scott Bender
Scott Bender8mo ago
There’s some work being done https://github.com/canboat/canboat/issues/309
GitHub
Reverse engineering of Navico autopilot controls · Issue #309 · can...
(A lot of) work has already been done on this by @htool, see https://github.com/htool/RaymarineAPtoFakeNavicoAutoPilot Hans' focus was to be able to use a Raymarine AP with a Navico control hea...
Kees Verruijt
Kees Verruijt7mo ago
Yup. I didn't get much further with this this year, too much else going on, but maybe @HansT can shed some light on his progress?
HansT
HansT6mo ago
No update from my side.
Timberwolf
Timberwolf3w ago
I have spent the two last nights trying to make a working AC12 emulator based on the data i can find in RaymarineAPtoFakeNavicoAutoPilot the above discussion in canboat/canboat and other sources. I can make it work on my Vulcan, but my Triton 2 displays "commissioning required" about 15 seconds after i start the emulator.
before that it is activated and displays all information on the AP screen. My hypothesis is that it times out due to errors in my periodic messages or that i am missing a message or timing of a message. Any additional log files would of course be super valuable. Chat GPT is a great collegue reading raw candump files...

Did you find this page helpful?