VC4 300 frequency response what can i do better?
Hi i test the half day but the result is most of the time equally
Maybe are the Belt length are the problem?
Maybe are the Belt length are the problem?
5 Replies
Could be the upper belt has fewer teeth then the lower
How can i check this without dismantling the machine) 🙂
I'd say this graph is pretty good actually. Two peaks and pretty smooth lines for both
Yes to be clear it is good but some want to push the edge.
Very carefully loosen the back grabber and pull listen for a tooth to pop though if you cut your belts short already I would leave it sorry didn't realize you posted another update
What do your input shaper graphs look like?