having trouble installing ratOS
I have a v minion kit and was trying to finish it and when I try to use etcher to flash sd card it fails every time at 100% during validation. Don't know if it is actually flashing or not, but I've tried 4 different sd cards, and tried plugging in to the Pi but it never creates the hotspot so I assume it isn't flashing. Anyone have this problem?
5 Replies
Is this Balena Etcher? Some versions don't work too well.
https://discord.com/channels/582187371529764864/1268295547937362040/1268335045286957067
yes, I used the link in the rat rig instructions
Solution
Ok, like that link says, try the raspberry pi imager, or Rufus
ok, I didn't see that. I'll give those a try. Thanks!
If you are using the latest Ballena Etcher you are not the only one that has had problems. Revert back to version .18, you should not have problems with that version.