RRC
Rat Rig Community [Unofficial]•3w ago
E-TF[102] Riker

X and Y moving simultaneously

Hello everyone, I recently had to rebuild my printer after it suffered a catastrophic failure. Now I have everything working again, however as you can see from this video when moving in x it jumps a little in Y, and vice versa. My belt tension appears to be okay, so I’m a bit stumped .
No description
No description
Solution:
Problem solved. Screw was lose on the stepper motor pulley
Jump to solution
1 Reply
Solution
E-TF[102] Riker
E-TF[102] Riker•2w ago
Problem solved. Screw was lose on the stepper motor pulley
Want results from more Discord servers?
Add your server
More Posts
updating ratOSIs there a place to check component versions compatibility before updating in Update Manager? TIA✌️neopixel lights macro automationHey there. Is there a way to add functionality to RatOS so that my lights_on and lights_off macros gRatOS Hard recovery - Not working , can't recover by SSHAfter doing an Hardrecover of the RatOS, i cant reboot my OS, receiving the message as seen on firsADXL mit Pi Pico ProblemHallo zusammen. Seitdem ich RatOS 2.1 installiert habe, bekomme ich ADXL an alle Drucker nicht mehr ADXL Raspberry Pico ProblemHello everyone. Since I installed RatOS 2.1 I can't get ADXL to work with Pi Pico. To all my V-MinioHorrible Top Layer and a groove?Just wrapped the guides and finished PA/EM so I decided to do a cal cube. This is an untouched PrusaBeacon start up print Move out of rangeSo when i finally got my beacon up and running after some fiddling. I went to start a small test priInput shaper error in configI'm getting the following error when I'm trying to setup a fresh install with ebb42 v1.2 and beacon.