EXTRUDER OCTOPUS RATOS 2.1
Is there a way to put the extruder from the octopus and not from the toolhead?
20 Replies
No, it's pretty much assumed you would want to use the toolboard when you paid for it 😂
What's the use case?
I bought the ratrig v core 3.1 second-hand and it came to me that it has the extruder on the board hahah
I think it's better to cut the cables and put it in the toolhead...
i agree
okey thx for the asnwer ❤️
@miklschmidt now i cable on the toolhead and throw this error
:sadpepe:
https://www.klipper3d.org/TMC_Drivers.html#tmc-reports-error-uv_cp1undervoltage
Check your toolboard power wiring and make sure you took off the V_USB jumper
okey i check it
(or maybe we're about to discover why the previous owner ran his extruder wires back to the octopus.)
prolly a good idea to inspect the toolboard for damage
only i have de 120r but i dont need no?
i dont have canbus, i use the usb
Most likely, I think I'll buy a sht36 v3 so I can update it a little 😉
exactly
We don't have support for that one yet.
Check the power wiring here.
this is okey becose the heater works good
also is this mounted on the printer? This will break real fast, there's no strain relief.
you won't notice a loose power connection as fast on a heater.
what? the cable usb c?
The extruder plug doesn't look properly seated, but hard to tell from the picture
The power wiring, i can't see the USB-C wiring, but judging from the rest of it, that's prolly not great either.
Also the USB-C connector should really be tied down.
I just put the tester on and it goes to 24v, it's fine
The order colors is correct ?
wouldn't cause the error even if they weren't
the driver is complaining it's not getting enough juice.