Internal bridging issues
I have a problem where internal bridges will not connect to the perimeters, leaving the filament to curl at the edges and thus making the following layers ugly. I can't seem to find the correct setting in the slicer to make this interal bridge reach the edges. Can somebody tell me, what to change in my setting?
1 Reply
Cura has a setting called "Infill wall count" that might help here, you could also try and see if adjusting the infill overalp helps. I am not sure about prusa/super slicer but in orca and bambu studio there don´t seem to be any settings that would help here.
Personally I would look into why the edges are curling (print temperature, cooling, drafts, etc.), as most printers should be capable of printing the internal bridges as they are. That is probably also why most slicers don´t include a setting for adjusting this.