Setting up USB Camera
I believe i have all of the settings right for the usb camera, it is plugged into my Pi and visible as a device on my printer. But the videso doesnt show
5 Replies
Have you fixed it?
I see in your config that your section header has a capital 'C'. ie
[Cam 1]
instead of [cam 1]
. Not sure if it's case-sensitive. I would also remove the new line between the header and mode
just to be safe. It probably doesn't matter but still.
also, I think mode
only takes ustreamer
or camera-streamer
as valuesMy crowsnest.conf that works is almost identical except the two things that @ADSRMedia pointed out.
Change it to
cam
and change mode to ustreamer
.I also didn’t initially realize that this post is from May so we may never get a response.
Damn you Sky217 for necroing a thread!