Tony - Shout out to @mairas for including heade...
Shout out to @Matti Airas for including header pins for both the one wire and the GPIO for HALMET. Now I only need pin connectors to connect sensors. A lot less work on my end now. Thank you
3 Replies
The next logical question is why on earth the headers are not pre-soldered like on SH-ESP32. 😄 The reason for that since the GPIO and 1-Wire connectors are at the edge of the board, they might limit panel connector placement on the enclosure. So, I left that for the user to decide and do.
Makes sense to me. On that note, I have been using a cheap solder iron and am looking for one that would be more accurate for pins on PCBs. Any suggestions for a new one?
Yes! Let me ramble about it later tonight.