Mesh v-core 3 400x400
any suggestion to which rail i should try to move up or down?
it looks kinda flat except the back left corner :/
2 Replies
i watched also https://www.youtube.com/watch?v=h7ZTq2dDTkM&ab_channel=3DPrinters%26aWhiteboard but it looks like is doesn't really matter if i move the left front side a little up or down, seems to get just worse
3D Printers & a Whiteboard
YouTube
RatRig V-Core 3: How to Get a Square Frame
This video is for those who struggle getting bed meshed with their RatRig V-Core 3.
Please feel free to jump to the chapter you are interested in.
0:00 Intro
1:05 about the v-core 3 frame and bed leveling
8:26 what to take care of in the building phase
9:17 the right square
10:09 build tips
16:50 adjusting the frame according to your bed mesh
...
im pretty sure the bed is a little bit warped, using a normal 40cm 📏 ruler
putting the ruler on the thin side diagonally on the bed, the ruler is floating in left back corner. but when change ztilt positions so that 300x300 in the center of the 400x400 is used and mesh 300x300 i go down to 0.105 Range
before i was at 0.2 range when using adaptive mesh for a 200x200 print when using the 400x400 z tilt positins
putting the ruler on the thin side diagonally on the bed, the ruler is floating in left back corner. but when change ztilt positions so that 300x300 in the center of the 400x400 is used and mesh 300x300 i go down to 0.105 Range
before i was at 0.2 range when using adaptive mesh for a 200x200 print when using the 400x400 z tilt positins