pressure advance values not respected in printer.cfg

The printer isn't using the set .3 pressure_advance setting

# Pressure Advance
# Check https://www.klipper3d.org/Pressure_Advance.html for pressure advance tuning.
[extruder]
pressure_advance: 0.3
dir_pin: e_dir_pin # Add ! in front of pin name to reverse extruder direction
nozzle_diameter: 0.4 # Remember to change this if you change nozzle diameter.
#control: pid
#pid_kp: 21.673
#pid_ki: 1.338
#pid_kd: 87.776

# Pressure Advance
# Check https://www.klipper3d.org/Pressure_Advance.html for pressure advance tuning.
[extruder]
pressure_advance: 0.3
dir_pin: e_dir_pin # Add ! in front of pin name to reverse extruder direction
nozzle_diameter: 0.4 # Remember to change this if you change nozzle diameter.
#control: pid
#pid_kp: 21.673
#pid_ki: 1.338
#pid_kd: 87.776

4 Replies

Prav•11mo ago

it probably gets overridden by the slicer eg. like that https://yko.im/8HhN.png

VanOfHoogenOP•11mo ago

its not part of it but, I can add it to see if it will pick it up

VanOfHoogenOP•11mo ago

found where it was being overriden closing issue

Gaming

Programming

pressure advance values not respected in printer.cfg