Why is one side okay and the other not?
Seam is on the back.
Top surface looks a bit strange
First layer 0.2
Other 0.15
Nozzle 0.6
8 Replies
does your part cooling fan have anything like a hole on the left side?
Will check tomorrow
And let you know
@iac009 No visible holes 😦
try this
take a small (and i mean small amount) of dish soap and mix it with water
bush a small amount on the blower and fun the fan at a low speed
slowly ramp up and look for bubles
do this to both sides
you might have small pinhole leaks
also is this printer in a enclosure
?
Will give it a go
Its not enclosed
Btw its a Minion
this is PETG
forgot to mention
if your cooler is not the prob then because its not enclosed is any draft or fan near the left side that might be effecting it
i used to have mine next to a wall where the floor heater was and caused a simmilar prob when it turned on at night
i ended up making an enclosure out of old cardboard poster boards to help durring winter
Yeahh
I think you're spot on there
Will try and enclose it with something cheap to test
The easy way to test it is to turn the printer 180band print one more and it should show up on the other fin
did everything work out for ya
Haven't had time to check