layer shift
It starts to print in position but while is printing after some layers it seems that is moving, it prints a few layers more and then is moving more. Whats that?
5 Replies
Solved, it was my belts, a little loose
I think the belt would have to skip over on the stepper pulley for that to happen, unlikely loose belt if so.
More probable that the grub screw on the pulley on the stepper isnt tightened down properly and slips occasionally, tightening the belt may have added friction but if the grubscrew is still loose its probably gonna slip again.
How did you tighten the belt? Pulling the motor further?🤔