Symlink klippy extensions
I'm trying to follow the guide to fix a Klipper hard reset, but I don't have the "actions" dropdown anywhere on the page oddly..
12 Replies
Looks like a very old version of the RatOS configurator
Are you on v1?
judicial-coralOP•12mo ago
Yeah my three Rat Rigs have been down for a good while, I've been in the middle of buying house/moving. Just getting them going today.
Lemme look
RatOS has been discontinued since may
No longer supported
I believe you only need the gcode_shell_extension plugin however.
https://github.com/Rat-OS/RatOS-configuration/blob/v2.x/klippy/gcode_shell_command.py
Put this in ~/klipper/klippy/extras
GitHub
RatOS-configuration/klippy/gcode_shell_command.py at v2.x · Rat-OS/...
The RatOS modular klipper configuration. Contribute to Rat-OS/RatOS-configuration development by creating an account on GitHub.
And you should be good to go
judicial-coralOP•12mo ago
I would advise updating to RatOS v2.x (that's a reflash, it's not backwards compatible) when you have time as future klipper/moonraker changes very well might break your V1 setup
yeah that's old af 😄
judicial-coralOP•12mo ago
Oopsy
I'll have to do all three
try this
At least that'll get you going
judicial-coralOP•12mo ago
Excellent thank you sir.
Then you can update if you run into further issues
judicial-coralOP•12mo ago
Boom, all set. I have a couple minor parts to print to fix a broken camera mount on the 500mm 3.0, then I'll reflash all three. (500mm 3.0, 200mm 3.1, V-Minion)
Thanks again!