Octopus Pro H723 flashed over Ratos dfu mode no connection
in Klipper log stands
mcu 'mcu': Starting serial connect
mcu 'mcu': Unable to open serial port: [Errno 2] could not open port /dev/btt-octopus-pro-h723: [Errno 2] No such file or directory: '/dev/btt-octopus-pro-h723'
webhooks client 547981088992: New connection
and in Xterm i can see with
ls /dev/serial/by-id/*
/dev/serial/by-id/usb-Klipper_stm32h723xx_btt-octopus-pro-h723-11-if00
how can i change it
11 Replies
with dmesg -w
when i reconnect it
Boards should be flashed via the RatOS configurator
Please read the documentation
still the same over automaticly flashing
this is my config for my printer
i tried automtaicly flashing
and DFU
/dev/serial/by-id/usb-Klipper_stm32h723xx_btt-octopus-pro-h723-11-if00
after restart
even flashing with sd card
Sorry, i just noticed it has
btt-octopus-pro-h723-11, so it was flashed correctly, that id should map it to /dev/btt-octopus-pro-11. You're including the wrong config, it should be:
and not [include RatOS/boards/btt-octopus-pro-h723/config.cfg]thx ... that 11 was indeed the key komponent thx u helped alot... i thought it is the right one as there only stands the 1.0 one
Yeah i think that's because you installed the v-core-3 template before updating RatOS (which brought support for the 11) 🙂
Not exactly obvious with those copied templates. Those are gone in 2.1 fortunately.
u could be right with this sadly i could only reverse it if i put a fresh image on it or
No no there's no reason to do anything. It's just that line that was added, you're fine 🙂
thx now waiting for the plate to finish the printer