Stuck on Initializing

Havent used printer in little while and when i went to try and connect to it today via ip address it just gets stuck at the Intializing screen. I did get a new router and setup everything on different IP range then the default so thinking it was related to that now. Tried reinstalling RatOS from scratch, tried installing klipper via KIAUH, and get the same issue. Have RatOS installed on it again and can connect via Putty or WinSCP and KlipperScreen is working but just get the initializing screen on web. I attached screenshot of the initializing page its stuck on and a moonraker page i got to by putting port 7125 in the address that i saw somewhere. Adding ip range for home network like it says in that moonraker error on there does nothing. Stuck here not sure what to do. Would rather not have to do everything on it without the web gui. Thanks.