Gaps at the end of perimeters

I'm havign an issue where my perimeters dont close all the way, this is a new issue that started when I switched to a 0.6 nuzzle.
I made sure to switch to 0.6 in the slicer and in the printer.cfg

printed in PLA in 215c, 100mm/s, 5k accl, PA 0.032

SwissStar_BL_2•9/6/23, 8:55 AM

Did you recalibrate flow and PA?

sacred-roseOP•9/6/23, 8:55 AM

I also ran a PA test again as shown in the picture below, and reprinted the part with 0.03 and also the confirmation in the console that it was set to 0.03 at the start of the print

sour-pink•9/6/23, 6:17 PM

Maybe check your retraction settings. What extruder/hotend? Slicer? In Orca I had something enabled that did a wipe towards the inside on retractions and caused something similar. If everything fails maybe add some extra de-retraction distance

huskyte•9/7/23, 8:03 AM

What are the retraction settings and what hotend are you using?