Pringles shaped bed?
Hello, I did a bet mesh and it came out like that. I have the 500mm vcore 3.1. I was wondering if -0.62 and +0,49 are good or bad? Is there anything i can try to fix this?
11 Replies
Hi, this is pretty bad and needs some frame correction
Please refer to this video, you have pretty much the "default" issue mentioned at this timestamp: https://youtu.be/h7ZTq2dDTkM?si=V6jEgawe1MS82K4A&t=1005
You will want to bring the front right corner down. Take small steps, re-check and repeat until both rear corners are the same level.
3D Printers & a Whiteboard
YouTube
RatRig V-Core 3: How to Get a Square Frame
This video is for those who struggle getting bed meshed with their RatRig V-Core 3.
Please feel free to jump to the chapter you are interested in.
0:00 Intro
1:05 about the v-core 3 frame and bed leveling
8:26 what to take care of in the building phase
9:17 the right square
10:09 build tips
16:50 adjusting the frame according to your bed mesh
...
Alright, I will try it. Thank you!
is this better? should i do more?
It's a tiny bit too much now, either raise the right front a bit, or lower left front
Then the rear 2 points should be same height
Okay, did that. Currently running a new mesh
Is there anything else i should do?
Or is this fair enough?
I think thats fine for the 500mm bed. 
Thank you very much. I was already worried i would have to rebuild the frame.
Nono. I have no idea, if the remaining sag can be improved a bit further, but I wouldn't touch it for now.