EBB42 - Klipper doesn't use the extruder port
I have been battling with this problem for 2 weeks, and the result is the same.
Klipper still goes through my Octopus V1.1 while I would like it to go through my EBB 42 V1.2...
I attach with the printer.cfg and the logs report.
Please help me !
#EBB42 #Octopus
7 Replies
rival-blackOP•2y ago
fair-rose•2y ago
fair-rose•2y ago
comment all I circled and try again
if you have a toolboard you need to "disable" standard config by commenting # everything you "move" to toolboard
rival-blackOP•2y ago
I have this but i must leave [probe] for z_offset
rival-blackOP•2y ago
fair-rose•2y ago
that is a problem with the stepper driver/motor
check the power and wiring to board/ebb/steppers
rival-blackOP•2y ago
I looked and indeed the TMC chipset failed...
Bon bah I am good at recommending a new one, thank you for your details.