"probe points"in section heater bed error
I am doing a new install of ratos and i can't figure this error out
any tips on how to fix it?
6 Replies
Yes, you made an error in printer.cfg, you probably missed a
[section] headerambitious-aquaOP•2y ago
ok so i replaced the file with the template and now the error is fixed but now it cant connect to the mcu
And you commented out the right board, verified the board through the configurator, etc?
ambitious-aquaOP•2y ago
only have this one
ambitious-aquaOP•2y ago
doesn't find the board when i am using the configurator
but i think it found it and then i updated everything using mainsail and now i only have the one in the screenshot
ambitious-aquaOP•2y ago
