Bad probe location bias
So I have been fighting this issue for weeks now. Basically my mesh suggests that my bed has a sinkhole right in the middle when in actuality it is the probe thats giving me a different z offset depending on x/y coordinates.
I already re- squared the hole printer - it was not too far off but i got it spot on now but nothing really changed.
My z offset ranges between .1 to .3 mm.
What should i try next after changing belt tension, trying x twist compensation and buying a genuine superpinda probe?
3 Replies
Bed size? Probe type? (inductive, euclid/klicky switch, bltouch etc) just as a cheap test.... buy a sheet of glass to lay on the print bed and test
quickest-silverOP•16mo ago
Obiously i forgot Some info. Its the 500 model and i recently enlosed it.
The probe i am using is the Superpinda off of a Prusa.
What would the test using the sheet of glas look like?
ok...with an inductive probe needing the metal sheet, put the glass under the print sheet...it's just a 'known' flat surface as a reference