klipper error when mainsail is started
Just flashed my board and got into mainsail and get this error after it tries to connect to klipper? Any help on this would be appreciated
3 Replies
rare-sapphireOP•2y ago
Just wired in the board to the printer and I'm still having the exact same error
Okay so I found and followed the troubleshooting guide for "section 'gcode_shell_command generate_shaper_graph_x' is not a valid config section" and used win scp to put the extension into klipper and nothing changed at all
Apparently a full power cycle on the printer fixed the issue 🤷♂️🤣
Reminded me to fix the troubleshooting section, there's an easier way to do this in v2:
This happens if you hard reset klipper through mainsail, to relink the extensions go to the configurator at http://ratos.local/configure, click the "Actions" dropdown menu in the top right and pick "Symlink klippy extensions". Then go back to mainsail and restart the klipper service by clicking on the power icon in the top left corner, then the refresh icon next to "Klipper" under "Service controls". You should now be back in action.This is done automatically each time klipper, moonraker or RatOS is updated through the update manager in mainsail.
rare-sapphireOP•2y ago
Ooooooo that would have been easier! I got there eventually though!