Y rail sound. Normal?
Hi,
I just reassembled my vcore and wanted to know if this Y motion/sound is ok, the printer is square, the rail is square to the front frame but the sound is not the "smoothest"
4 Replies
if you can 'fling it' and it will slide all the way to the other end without binding it's fine
deep-jadeOP•2y ago
it will depending on how hard I push it
A test to see if ther is actually a 'bind' ... use a light rubber band as a tool to drag the gantry down the axis...a stretch change lets you know where it's binding if at all, or enough to care.
deep-jadeOP•2y ago
it will hit the end that is why in the clip I am not pushing it too fast
thanks!