Temperature fluctuates by 1.5 degrees.

Running a mosquito magnum.

2 Replies

audiorazor•13mo ago

did you run a pid tune?

DemetriKarakashev•13mo ago

I ran one when I was setting up my printer. Could things have changed since then? Running one again now. It was the part cooling fan changing speeds I think.

Rat Rig Community [Unofficial]Join

12KMembers

View on Discord

Want results from more Discord servers?

Add your server

Static IP ConfigurationWhat is the proper procedure to set a static IP address for the eth0 connection on RatOS? There app Idea? Bedmesh is completely off worldHello Together I have been trying to set up my BedMesh for a few days now. Unfortunately without a AWD TMC 5160 issueIve built the mechanical aspect of the AWD setup and am now currently trying to program it it RatOS,CAN w/ SKRat v1.0 and EBB36 v1.2Using BTT SKRat v1.0 w/ EBB36 v1.2 - via the CANBUS port. I have flashed both MCU and EBB36 using Ra stuck lower belt?While attempting to use Ellis' max speed tuning macro here: https://ellis3dp.com/Print-Tuning-Guide/Weird ~117Hz X Resonance and Belt Tension GraphI have a Vcore 3.1 500mm that is sitting on the floor. I am getting an odd peak in the X-direction a Good/Bad? RR vCore3.0 500First, I watched the video. I'm not sure how much I understood from it, but think these are ok, but sensorless homingHi I’ve changed over from endstops to sensorless on my Voron but it’s homing in the wrong corner. Ca y motor helpHey do anyone know how to fix my y motor? When homing y the y motor spins the right way but when hom Probed after heating shows upwards bow down the centerI managed to get the back corners within 0.021 of each other. However, when heating the bed, it warp

Gaming

Programming

Temperature fluctuates by 1.5 degrees.