Please load new filament and resume
Gday guys,
I am having some issues with my vcore 3.1 500 since two days now. Slicer: orca slicer
Basically, printers does the primeblob and straight after it, it "pauses" in park. 2 issues :
- Please load new filament and resume
- Unknown command:"T4"
I am pretty sure it comes from the slicer but I can't find any information about t4 command. Also, I don't know where to look for the "change of filament".
Solution for me is to : extrude/load the filament again and resume the print when the filament starts to extrude again.
Thank you for your time.
8 Replies
exotic-emerald•2y ago
You probably should post the macro you're trying to run
I am not using any macro, just the factory start g-code
exotic-emerald•2y ago
So what kind of start Gcode are you trying to run?
conscious-sapphire•2y ago
does it print a file from another slicer? if yes then issue is w/ slicer G code. if no then issue is with klipper start macro..
search the gcode file for the "t4" line and see whats around it.
prob filament start dcode or typo in your main start gcode in slicer
exotic-emerald•2y ago
That's the point, after the primer blob there shouldn't be any filament unloads ор loads, and T4 isn't a standard gcode command.
conscious-sapphire•2y ago
conscious-sapphire•2y ago
conscious-sapphire•2y ago
based on my test. it's prob in the slicer just after the initial klipper line. in your start Gcode section