Any tips to solve Y-axis valley?
I just retightened all the screws going from the front to the back.
2 Replies
this is a good bed mesh
you can totally use this
below 0.2 for a 400 is quite good
Thanks 🙂 I was around 0,28 and had some first layer issues so I had to improve it, now I'm indeed at a good enough point.
If there is anything I'm missing about the Y rails I would ofcourse love to get it under 0,1 😄
By the way, I ordered the beacon probe to do faster bed meshing, and was wondering if that enables me to do auto z calibration. I think I'll still need a physical z stop to do that somewhere in the back but I'm not sure.