v-minion z rod noise
Hey, my v-minion has developed a noise when moving down a certain section of the z axis. See video for noise.
7 Replies
generous-apricot•2y ago
I have this too and would be interested in the answer!
did you lubed the leadscrew?
you could also check if the leadscrew is correctly centered
I do notice lots of wobble. Will grease it
if you have wobble then you need to center your leadscrew correctly
needs to be centered on the bottom and the top
could also be a misalgned rail
or a non 90° angle for the extrusion
....
So many more tools to buy
Don't have a true 90 deg square
Will investigate futher and check spacing/alignment
trust me, you can use this without any issue, there is no need to spent 30 40 or 50 bucks for a engineering tool