Rat Rig Community [Unofficial]•2y ago

Board detected but unresponsive

I have an Octopus 1.1 and I tried reflashing multiple times. I tried doing it remotely, over sd card and also tried flashing octopus via 5V. When I do it remotely an error message appears and when I try manually it won’t fix the issue either.

2 Replies

unwilling-turquoiseOP•2y ago

At the moment I only connected the board to the pi and to power

miklschmidt•2y ago

@freddimura klipper isn't running. Try this:

ssh [email protected]
rm -f ~/klipper/klippy/chelper/c_helper.so
sudo systemctl klipper start

ssh [email protected]
rm -f ~/klipper/klippy/chelper/c_helper.so
sudo systemctl klipper start

Then wait 10 minutes and try the configurator again.

Gaming

Programming

Board detected but unresponsive

Did you find this page helpful?