Probe triggered prior to movement error on the v-minion
yesterday i printed good ... this morning i wanted to start again and homing was oke like always .. then the heating started to get the bed mesh and the he halted at the first place and got this error message
Probe triggered prior to movement .... i have already done new crimps to it .. when he homed i have gone to the machine section ... endstop and clicked the 2 white arrows everything came open green ...
has some one an idee where to look
2 Replies
absent-sapphire•2y ago
is this a pinda or a touch? If pinda check the mount. If touch try turning the printer off and pulling the probe out of the touch. After you do EITHER of these things please reset your z-offset or you run the risk of hurting your build plate.
national-goldOP•2y ago
its the stock one from the minion
i have false the bedmesh in the printer.cfg and started a print that went great....
the problem was the cable near to the eva mount so the mount on the eva 2 was straight and did to the break so i have to change the cable mount