adxl345 id (got ff vs e5) error
I've been trying to figure this issue out since i built my minion almost a year ago. I have made and tried about half a dozen wires in order to get my adxl345's to work. I've tried stepper motor wires, cat8, cat6 wired according to blacksmithforlife's setup and wires that work fine for input shaping on my voron 0.1. in single adxl mode I always get the error and in dual adxl mode it is able to test the x axis but then fails attempting the Y axis. I am honestly over cripping anymore network wires so if there is any vendor that sells premade ones please let me know.
1 Reply
adverse-sapphire•2y ago
I'm getting such error when disconnecting gnd ( black) wire. If it's connected than i got 0 vs e5