Issues where filament randomly leaves gaps and even doesn't print some lines
So I set up my printer, configured everything and tried a cali cube, all fine except first layer was bit high up but then trying something else my printer did weird stuff, always in the same spot it is stopping to extrude filament (already tried turning PA to 0 and 0.05 but no effect. It comes to the point it even 'forgets' to print 3 full walls on the inner circle shown in the image. Also when filling the solid layer it leaves gaps at the same spots all the time and it kind of seems like it is going slightly outside the walls.
Is this firmware/slicer related or mechanically? I'm kind of out of ideas, it's my first klipper printer so not that experienced.
Also printing with a 0.6 Volcano nozzle
TIA
1 Reply
flat-fuchsiaOP•2y ago
Okey so, switching from orcaslicer to Superslicer changed a LOT! Didn't forget to print the circle walls, no more gaps... I used default ratrig profile on Orcaslicer but changed all parameters to 0.6 mm nozzle also lowered speed etc... but can't seem to get the orcaslicer work well on my printer
Sorry for this topic, but I found out that Orcaslicer uses G3 (think it's arc fitting?) Instead of G1 which is used by Superslicer, G3 cannot be read by Klipper?