Tightening the lower belt makes the moving the x axis a lot harder
As kn the title said when I’m making the gantry square the x axis gets a lot harder to move any ideas how to solve it ?
6 Replies
All the belts seem to be in the right place pls help I’m sitting on this since like 2 weeks
They are running in the right postion
Moving in Y is easy but X is hard moving it diagonally its easy also. I Untightende the pulleys and it still hard to move in x direction
conscious-sapphire•2y ago
ok, could be a couple of things.
but .. could the belt be .. too tight?
if you move the gantry with one finger, does it tend to go to one side while moving backwards and forwards?
overtightened idlers?
Without and with belt no
Don’t think so
conscious-sapphire•2y ago
ok, seems like @Helge Keck is giving advice you also could follow in #v-core-3 or #general ..
and me, because I tore my belt because it was too tight so I'm thinking of redoing the squareness..
The problem appears to be on the lower belt
The toolhead jitters when moving the y axis