V-Minion printing off center (Sensorless Homing)
I set up Sensorless Homing again recently on my Minion, as well as KAMP after seeing Modbots video (https://youtu.be/HydfV8h4p60). Since then, my Minion has been inconsistent with where it starts the print. Of course, I've made sure it's properly centered in the slicer (OrcaSlicer).
2 Replies
harsh-harlequinOP•2y ago
Here's my printer.cfg and sensorless-homing.cfg, based on settings recommended by Helge Keck
no
these settings are for an very old ratos version
DO NOT USE THEM
you just need to tune your endstop position value in the sensorless homing config
these values are mm values
if you think yur nozzle needs to go 5mm to the left then add -5 to the already existing value
and so on