Artifacts on v-minion in vase mode with 0.6 nozzle
I'm struggling to find why am I seeing artifacts when printing vase mode with a 0.6 nozzle on the v-minion.
- width: 0.85mm
- height: 0.46mm
- max vol. speed 13 mm3/s
- Dragonfly BMO + LGX Lite
- PLA
I've tried widths from 1mm to 0.85mm.
Curiously enough, these artifacts are consistently not happening on the perimeter facing front.
This doesn't happen with a 0.4 nozzle and 0.35 h / 0.45 w
5 Replies
did you set the new nozzle size in klipper config as well?
people often forget that
like-goldOP•2y ago
oh my... had no idea
where's that set?
nozzle_diameter under extruder section, make an override
like-goldOP•2y ago
gotcha, thanks a bunch!
🤦
okay I'm still getting them
@mitsuma what else could I check? pressure advance?
Can you send config for 0.6 nozzle>
?