Vibration on Left XY-Motor and Belt
Hello,
my RatRig V-Core 3.0 it makes noise as soon as the left xy-motor is running and I drive a little over 200mm/s fast.
The GT2 belt vibrates strongly.
The print quality suffers massively in these situations.
I have already checked the belt travel several times.
Even the pulleys seem to run soft and clean at first. I have replaced the motor and the TMC as a test. however, the error remains.
Unfortunately, I'm running out of ideas
1 Reply
equal-jadeOP•2y ago
I could observe that apparently only the stepper brings in the vibrations. An exchange of the stepper brought no improvement. will now exchange the TMC2209 of x and y again.