16 Replies
So more tension on the lower belt ?
other-emerald•2y ago
Yea but loosen the top same amount as you tension lower
Ok
it destroys the squareness
then it aint sqaured tried this for almost an hour
other-emerald•2y ago
I worked 2days on mine
its out of square tension is not even or its binding

Is this ok ?

lower tension on upper and higher on lower?
other-emerald•2y ago
Its your printer you decide whats ok,its not perfect but heck a lot better.
what would you say
i will give it a try and mybe get it perfect
other-emerald•2y ago
I would try some more
Baby steps
getting closer

i think thats good enough

other-emerald•2y ago
Hows the x/y graphs then?
gonna check now
good?


other-emerald•2y ago
Much better 👍