23 Replies
you need to calibrate your gantry
- release the belts
- loosen the xy joiner screws
- move the gantry to the front
- press the gantry to the front and at the same time tighten the screws again
- recalibrate your y rails
- retight belts
- equalize belts by checking if the gantry hits both sides at the same time
Those screws ?
just loosen them a bit
also the 2 M5 bolts
what do you mean with recalibrate your y rails?
losen then or so?
i used these centering blocks
- loosen the rail screws
- move the gantry to the front
- tight one screw on the rail, where the gantry is
- move the gantry to the back
- tight one screw on each rail where the gantry is
- do the same for the center
try to move your gantry forward backwards, to see if it moves freely
Better?
@helgekeck does my lower belt need more tension?
or should i run vibration thingy
with this please move over to #fix-my-resonance
but does it look good?
i will run vibration compenstation test?
this is the goal
400000 wtf
ignore that numbers
they do not tell you anythiung
you mean that they are similar?
yes
please move over to #fix-my-resonance
where are under #fix-my-resonance
open a thread there
Moved over
how in the world did you got this so perfect
patience
and brute force
hdym
is this ok?
this is not the correct channel to discuss this
you have a open thread in fix my resonance
please read the posts in #fix-my-resonance and you will learn a lot