Phaetus Rapido UHF + Volcano CHT Nozzle + LGX Lite
My setup seems to skipping extrusion steps at only around 15 mm³/s
PLA+ at 210-225 did the same thing, heat didnt seem to help should I keep going hotter?
I am using the lgx-lite 0.85a extruder config and default rapido config in the latest RatOS v1
6 Replies
the lgx lite is not very pwoerful
combined with your low print temperature this is the maximum you can get
passive-yellowOP•2y ago
ok
I have orbiter v2 and cnc hextrudort
raise the temp a bit
passive-yellowOP•2y ago
time to print new top pieces 🙂
orbiter 2 is the way to go
passive-yellowOP•2y ago
thank you! for the replies, going to try hotter for now, and start getting my eva3 orbiter2 setup ready to go