Post calibration print homeall stops working?

homeall worked fine. Did my first real filament calibration print. Edited some params and went to start another print. HOME x worked, then stopped with the error

Must home axis first: 250.000 250.000 6.981 [5439.368]

Must home axis first: 250.000 250.000 6.981 [5439.368]

I manually had to move the head back out to the middle of the bed. did a HOME X, and it homed and backed off the stop as normal. Tried a HOME Y and gotthe same error again. Had to reboot and it then homed all properly. Did a HOME ALL, a z-tilt, then started a second print whic went as expected. More parma changes,,,, started a third print and the same thing happened again. X homes, then stops with the above error. See klipper log attached
WTF?? very wierd

klippy2.log4.81MB

miklschmidt•3/13/23, 4:20 AM

Don't know but i've never had this happen. It looks like you've made quite a lot of modifications and added a lot of third party stuff. I'd start there.

miklschmidt•3/13/23, 4:21 AM

You're getting a lot of neopixel failures too, but that's probably unrelated

miklschmidt•3/13/23, 4:21 AM

Something is printing to the log, which is also weird.

pteglerOP•3/13/23, 3:32 PM

dumbshit here.... in prep for moding a couple macros (start print, homing , cancel neopixel inclusion etc) I'd copied those macros to another file, and had inadvertently 'included' it in printer .cfg Commenting out that macro file include solved the issue. Again...dumbshit here...I realized I'd not updated that file to the v2 versions. It contained all 1.2.x versions of any macros I'd copied there.