2.0 udpate...moonraker backup issue
...didn't appear to save the history as checked when the backup was done. Do you need to do only one check mark at a time to get the moonraker db to dump so you can restore after the R) 2.0 upgrade?
5 Replies
ok...understand the backup would have been on the old TF card rather than the new TF card used for my 2.0 install. I have a full winscp copy of the entire pi/ So have the files. But how /where do I copy them back so the restore moonraker db function can se the proper files? when I did the intial backup under 1.2.x it wrote a json file to my DOWNLOADS folder. But how is that supposed to see the database files that are on another drive?
Short discourse attached. Perhaps worth 'pinning' somewhere (after edits, or inclusion) for others bold enough to follow.....
Proper 32 bit to 64 bit upgrade as well as saving/retrieving all your moonraker db info, history, g-code files etc. It works! I got back everthing in the db!
thank you so much 😂 🙏
I fu*** the last two days around finding a solution
just one quick thing
I think it should be
sudo service moonraker stop
because with sudo services moonraker stop
it says command not foundwrite up does state sudo...start sudo... stop
Yeah yeah but I meant it should say service not services in the commands
fixed.