Perimeters print fine. Infill breaks up.
So as per title, ASA, my perimeters print fine at 150mm/s. However, my infill at same width and speed breaks up. Any ideas?
![No description](https://cdn.answeroverflow.com/1079871343354462288/CFBA9E4F-27A0-4618-A471-7B941326FD1D.jpg)
![No description](https://cdn.answeroverflow.com/1079871343954231427/39615371-47CC-4882-9D38-475DDDF6B6F9.jpg)
![No description](https://cdn.answeroverflow.com/1079871344793108601/93110DC7-639F-477E-846C-ECC5ECEA5F34.jpg)
![No description](https://cdn.answeroverflow.com/1079871345686478901/6DECD1F0-F802-4FD1-9E39-CFFFE6D94CEF.jpg)
3 Replies
change your infill line extrusion with... (not the infill %)
Default seems to be at 0.6mm for a 0.6mm nozzle. is there any rule of thumb for how much to set it at?
I use 0.72 for all lines
Especially for single wall infill, don't use anything under 0.7