Well damn....after enclosure 2.0
Anyone remmeber which side I need to pull and such?

3 Replies
left front corner (Y linear rail extrusion) has to rise, right front corner needs to be lowered
remember to do a z-tilt before the mesh test
absent-sapphireOP•3y ago
Thanks!
You think this is the best I will get?
(cold)

is this cold or hot? printer bed size? (300,400,500?)
500s, yes there is center of the bed sag... one quicky test... add a couple (side by side) strips of blue painters tape across the width of your magnetic base plate (under the print sheet) to raise the center and run a mesh. Tape (usually layers of Kapton tape) on the magnet is a common work around.
Or you can get stupid like me.... https://discord.com/channels/582187371529764864/1056263255842099331/1056646821683937470