Strage extrusion and z-offset behaviour
Hi, I have a v-minion. Always printing good. But from some time I having problems with the z-offset and the extrusion. Both my slicers (Cura and SuSl) are setted to relative extrusion like in RatOs variable. My z-offset is correctly calibrated. But randomly, from print to print, I get irregular extrusion or incorrect z-offset (or too low or too high). Sometimes reboot the firmware is the only solution to fix it. Any ideas?
1 Reply
firm-tanOP•2y ago
I noticed that sometimes bed mash had negatives number, and result under the bed. Can this behaviour affect the z-offset and cause the problem? I'm using PAM and a normal pinda (not the superpinda one).