bed mesh spike on vcore v3.1 300mm
Hi
I am going to be doing some large prints on my 300 and need the bed to be as flat as possible to avoid warping ,so I did a 15x15 probe count bed mesh to see how bad it was .
Anyway I know the height maps can seem worse than they actually are and I have a crazy spike in the left front corner and I am wondering what I need to do to sort it or should I just leave as is.
Any help gratefully appreciated thank you.
5 Replies
Does anybody have any input please?
fair-rose•2y ago
You could leave it this way tbh
I have 0.2-0.4 variations and havent had warping issues with large prints.
Ok that's good to know ,mine just looks over exaggerated maybe
fair-rose•2y ago
I mean
Its a bit spiky
But you shouldnt look just at colors
Its better to look what they mean
0.2mm from highest to lowest realistically isnt much
If I would see any problems with actual prints then I would investigate.
Ok cool thank you