I uh never done this before, looking clean
If anyone could just help explain to me what was going on here that would be amazing, it dose not have to be anything crazy, but simple something. Thanks
16 Replies
Belts too loose, adxl too loose or binding somewhere
rival-blackOP•3y ago
Binding? What do you mean by that? And how can I find the best tension for belts of a 400? Would a wireing suspend for the adxl causing the problem
Too much friction
rival-blackOP•3y ago
how do you know this? so i should tighten the belts huh
You don't have a narrow peak, but it's all over the place
rival-blackOP•3y ago
i tighten up thebelts. here it is
rival-blackOP•3y ago
I have some pannels with loose screws on the side of the printer that arent mounted, could that be a problem to?
also another printer shakeing alot on this desk
The double peak is not ok. The table could be resonating too if it has some flex. You need something stable, the panels could be an issue.
rival-blackOP•3y ago
thanks, so the dubble peak. what could that mean? or what dose that mean is happing?
Something has a resonance frequency around 110hz
And that affects the printer
rival-blackOP•3y ago
like a loose screw?
Could be something attached to the toolhead
Think a bit bigger
Cables, loose back duct, long table
rival-blackOP•3y ago
so pannels maybe?
its on a 8x3ft table?
8 long 3 wide
Just watch, listen and feel during the test
rival-blackOP•3y ago
would a high speed bambu moveing fast on the table cuase that maybe?
when you say feel, whare exactly?
Find out what vibrates